| Peer-Reviewed

Determination of Optimum Cement Content for Stabilization of Soft Soil and Durability Analysis of Soil Stabilized with Cement

Received: 4 December 2017     Accepted: 18 December 2017     Published: 5 January 2018
Views:       Downloads:
Abstract

This research was aimed at finding the optimum cement content for achieving maximum compressive strength and stabilization in soft soil found in the periphery of the city of Chittagong. But, gaining strength was not considered enough unless it can be proved that strength was gained without compromising the durability. As such, durability test was performed on the samples stabilized with different percentages of cement. In this research three different soil samples were used. The samples were collected from three different areas within the city where future expansion of the city is expected. Six different percentages of cement by weight of soil: 0%, 2%, 4%, 6%, 8%, and 10% were used. Cement was mixed with soil at optimum moisture content. Cubes were casted and their compressive strengths assessed after a curing period of 7, 14 & 28 days. The durability test was done in two different cycles: 2 days wetting-drying and 7 days wetting-drying within a time frame of 28 days. The volume and weight were monitored after completion of each cycle of wetting and drying. The performance of the soils modified with different percentages of cement were assessed using Standard Proctor Test, Unconfined Compression Test and Durability Test. It was found that compressive strengths in the samples under test increased with the increase of cement content up to 8%. But when cement content is increased above 8%, the compressive strength increased but in a slower rate. At the end of durability test, it was observed that volume, and weight of the soil samples produced with 2, 4 and 6% cement changes with the variation in wetting and drying periods. But when the cement percentage is increased by 6%, preferably increased to 8%, no appreciable change in weight and volume were observed after the wetting and drying cycles. The samples going through the two days wetting and drying cycles under durability test showed greater unconfined compressive strength compared to samples going through seven days durability cycle of wetting and drying. It may be mentioned here that the three soil samples stabilized with cement did not show any major degradation in compressive strength during durability test.

Published in American Journal of Civil Engineering (Volume 6, Issue 1)
DOI 10.11648/j.ajce.20180601.17
Page(s) 39-43
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2018. Published by Science Publishing Group

Keywords

Standard Proctor Test, Unconfined Compressive Strength, Durability, Wetting- Drying, Stabilization

References
[1] Dr. Arora K. R, 2006. Soil Mechanics and Foundation Engineering. 376p.
[2] Ibrahaim M. Al-Kiki, Moafaq A. Al-Atalla & Abdulrahman H. Al-Zubaydi., 2011. Durability test of stabilized soil. Eng. & Tech. Journal, Vol. 29, No. 4.
[3] ASTM D 698, 2000, Standard Test Methods for Laboratory Compaction Characteristics of Soil Using Standard Effort.
[4] ASTM D 2166-98, 2000, Standard Test Method for Unconfined Compressive Strength of Cohesive Soil.
[5] ASTM D 559-96, 1996, Standard test methods for wetting and drying compacted soil-cement mixtures.
[6] T. Kamei, A. Ahmed, K. Ugai, 2013, Durability of soft clay soil stabilized with recycled Bassanite and furnace cement mixtures, The Japanese Geotechnical Society, 53(1):155 – 165
[7] Al-Refeai, T. O., Al-Karni, A. A., 1999. Experimental study on the utilization of cement kiln dust for ground modification. King Saud Univ. Eng. Sci. 11 (2), 217–232.
[8] Oriola, F., Moses, G., 2011. Compacted black cotton soil treated with cement kiln dust as hydraulic barrier material. Am. J. Sci. Indust. Res. 2(4), 521–530.
[9] Peethamparan, S., Olek, J., 2008. Study of the effectiveness of cement kiln dusts in stabilizing N-montmorillonite clays. J. Mater. Civ. Eng. 20 (2), 137–146.
[10] Salahudeen, A. B., Eberemu, A. O., Osinubi, K. J., 2014. Assessment of cement kiln dust-treated expansive soil for the construction of flexible pavements. Geotech. Geol. Eng. http://dx.doi.org/10.1007/s10706-014-9769-0 (Springer International Publishing Switzerland).
Cite This Article
  • APA Style

    Md Ali Ashraf, S. M. Shazeebur Rahman, Md Omar Faruk, Md Abul Bashar. (2018). Determination of Optimum Cement Content for Stabilization of Soft Soil and Durability Analysis of Soil Stabilized with Cement. American Journal of Civil Engineering, 6(1), 39-43. https://doi.org/10.11648/j.ajce.20180601.17

    Copy | Download

    ACS Style

    Md Ali Ashraf; S. M. Shazeebur Rahman; Md Omar Faruk; Md Abul Bashar. Determination of Optimum Cement Content for Stabilization of Soft Soil and Durability Analysis of Soil Stabilized with Cement. Am. J. Civ. Eng. 2018, 6(1), 39-43. doi: 10.11648/j.ajce.20180601.17

    Copy | Download

    AMA Style

    Md Ali Ashraf, S. M. Shazeebur Rahman, Md Omar Faruk, Md Abul Bashar. Determination of Optimum Cement Content for Stabilization of Soft Soil and Durability Analysis of Soil Stabilized with Cement. Am J Civ Eng. 2018;6(1):39-43. doi: 10.11648/j.ajce.20180601.17

    Copy | Download

  • @article{10.11648/j.ajce.20180601.17,
      author = {Md Ali Ashraf and S. M. Shazeebur Rahman and Md Omar Faruk and Md Abul Bashar},
      title = {Determination of Optimum Cement Content for Stabilization of Soft Soil and Durability Analysis of Soil Stabilized with Cement},
      journal = {American Journal of Civil Engineering},
      volume = {6},
      number = {1},
      pages = {39-43},
      doi = {10.11648/j.ajce.20180601.17},
      url = {https://doi.org/10.11648/j.ajce.20180601.17},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.ajce.20180601.17},
      abstract = {This research was aimed at finding the optimum cement content for achieving maximum compressive strength and stabilization in soft soil found in the periphery of the city of Chittagong. But, gaining strength was not considered enough unless it can be proved that strength was gained without compromising the durability. As such, durability test was performed on the samples stabilized with different percentages of cement. In this research three different soil samples were used. The samples were collected from three different areas within the city where future expansion of the city is expected. Six different percentages of cement by weight of soil: 0%, 2%, 4%, 6%, 8%, and 10% were used. Cement was mixed with soil at optimum moisture content. Cubes were casted and their compressive strengths assessed after a curing period of 7, 14 & 28 days. The durability test was done in two different cycles: 2 days wetting-drying and 7 days wetting-drying within a time frame of 28 days. The volume and weight were monitored after completion of each cycle of wetting and drying. The performance of the soils modified with different percentages of cement were assessed using Standard Proctor Test, Unconfined Compression Test and Durability Test. It was found that compressive strengths in the samples under test increased with the increase of cement content up to 8%. But when cement content is increased above 8%, the compressive strength increased but in a slower rate. At the end of durability test, it was observed that volume, and weight of the soil samples produced with 2, 4 and 6% cement changes with the variation in wetting and drying periods. But when the cement percentage is increased by 6%, preferably increased to 8%, no appreciable change in weight and volume were observed after the wetting and drying cycles. The samples going through the two days wetting and drying cycles under durability test showed greater unconfined compressive strength compared to samples going through seven days durability cycle of wetting and drying. It may be mentioned here that the three soil samples stabilized with cement did not show any major degradation in compressive strength during durability test.},
     year = {2018}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Determination of Optimum Cement Content for Stabilization of Soft Soil and Durability Analysis of Soil Stabilized with Cement
    AU  - Md Ali Ashraf
    AU  - S. M. Shazeebur Rahman
    AU  - Md Omar Faruk
    AU  - Md Abul Bashar
    Y1  - 2018/01/05
    PY  - 2018
    N1  - https://doi.org/10.11648/j.ajce.20180601.17
    DO  - 10.11648/j.ajce.20180601.17
    T2  - American Journal of Civil Engineering
    JF  - American Journal of Civil Engineering
    JO  - American Journal of Civil Engineering
    SP  - 39
    EP  - 43
    PB  - Science Publishing Group
    SN  - 2330-8737
    UR  - https://doi.org/10.11648/j.ajce.20180601.17
    AB  - This research was aimed at finding the optimum cement content for achieving maximum compressive strength and stabilization in soft soil found in the periphery of the city of Chittagong. But, gaining strength was not considered enough unless it can be proved that strength was gained without compromising the durability. As such, durability test was performed on the samples stabilized with different percentages of cement. In this research three different soil samples were used. The samples were collected from three different areas within the city where future expansion of the city is expected. Six different percentages of cement by weight of soil: 0%, 2%, 4%, 6%, 8%, and 10% were used. Cement was mixed with soil at optimum moisture content. Cubes were casted and their compressive strengths assessed after a curing period of 7, 14 & 28 days. The durability test was done in two different cycles: 2 days wetting-drying and 7 days wetting-drying within a time frame of 28 days. The volume and weight were monitored after completion of each cycle of wetting and drying. The performance of the soils modified with different percentages of cement were assessed using Standard Proctor Test, Unconfined Compression Test and Durability Test. It was found that compressive strengths in the samples under test increased with the increase of cement content up to 8%. But when cement content is increased above 8%, the compressive strength increased but in a slower rate. At the end of durability test, it was observed that volume, and weight of the soil samples produced with 2, 4 and 6% cement changes with the variation in wetting and drying periods. But when the cement percentage is increased by 6%, preferably increased to 8%, no appreciable change in weight and volume were observed after the wetting and drying cycles. The samples going through the two days wetting and drying cycles under durability test showed greater unconfined compressive strength compared to samples going through seven days durability cycle of wetting and drying. It may be mentioned here that the three soil samples stabilized with cement did not show any major degradation in compressive strength during durability test.
    VL  - 6
    IS  - 1
    ER  - 

    Copy | Download

Author Information
  • Department of Civil Engineering, Southern University Bangladesh, Chittagong, Bangladesh

  • Department of Civil Engineering, Southern University Bangladesh, Chittagong, Bangladesh

  • Department of Civil Engineering, Southern University Bangladesh, Chittagong, Bangladesh

  • Department of Civil Engineering, Southern University Bangladesh, Chittagong, Bangladesh

  • Sections